The TF-100 6-pin electric scooter display is an LCD control panel with an integrated throttle for compatible electric scooters using the TF-100 system. It supports 24 V, 36 V, 48 V, 52 V and 60 V systems.

TF-100 6-pin electric scooter display functions

The bright LCD is visible during the day and evening. It shows current speed, battery charge level, selected riding mode (Gear), total distance (ODO), trip distance (TRIP) and diagnostic error codes. Power and Mode buttons control the main functions, while a USB output supports mobile-device charging.

• Connector: 6-pin, with six contacts
• Weight: approximately 140 g
• Colour: black/red
• Barcode: 4779051995493

Compatibility and checks before ordering

Confirmed compatibility: Kukirin G2 Pro, Kukirin G3, Kukirin G4, Kugoo Kirin M4, Kugoo Kirin M4 Pro, Kugoo Kirin M4 Pro S+, Kugoo Kirin M5, Ausom Leopard, Ausom L2 Max, Toursor X14 and some OOTD models using the TF-100 system.

Possible compatibility, requiring controller and firmware checks: Kukirin G2 Max, Kukirin G2 Master, Kukirin G3 Pro, Arwibon Q06 Pro, Laotie ES18, Laotie ES19 and Boyueda models with a TF-100 controller.

Other electric scooters may be compatible if they use a TF-100 display, a 6-pin connector and one of the listed system voltages. Before ordering, compare your existing display model, connector type, pin count and operating voltage. Visually similar displays may be incompatible with your controller.

Diagnostic codes and fault checks

• E01: motor or Hall sensor fault.
• E02: throttle fault or stuck throttle lever.
• E03: controller fault.
• E04: brake lever or brake sensor fault.
• E05: battery voltage too low.
• E06: communication error between display and controller.
• E07: communication error between controller and display.

An E02 error, unresponsive Power or Mode buttons, a non-working throttle, or failure to switch on despite power reaching the display may indicate a fault in the display itself. E03, E06 and E07 often result from controller faults, damaged wiring or poor contacts; check the electrical connections before replacing the dashboard.

Replacement and package contents

Remove the old control panel, disconnect its 6-pin connector and connect the replacement display. Adjust the throttle position before finally tightening the mounting screws so it is comfortable to operate while riding.

The package contains 1 × TF-100 display with integrated throttle.